how to install Wheel hub bearing

• Prepare the vehicle and the necessary tools before starting the installation. Make sure they are clean and

in good condition.

• Make sure that the kit is the right one. Take the bearing out of its packaging at the last minute and place

it on a clean work surface.

• Clean the parts and assemblies located near the bearing and make sure that they are in good condition.

In particular, inspect for scratches, scrapes or dents on the hub, stub axle and drive shaft. Replace any

damaged or worn parts.

• Do not remove any parts which are not included in the kit.

• Never disassemble or separate the components of a bearing.

• For correct installation of the bearing, always use suitable tools.

• Always apply fitting pressure through the outer ring of the bearing, the installation force must never be

transmitted through the seal or inner rings (pressure through the seal or inner rings will result in internal

damage to the bearing, making it noisy and fail prematurely)

• Apply the tightening torques recommended by the manufacturer (this can be found on the label of the kit)

please check and download our catalog If you want to know more information.  we could supply wheel bearing can be found from our shop, such as Mercedes Benz , AUDI , Land Rover , Jeep , VW , Porschec , Toyota ,Ford , Jaguar Hummer , Rolls Rocyce , Citroen , Chevrolet . Hyundai , Lexus and other lux cars